Omron CS1W-LC001 Operation Manual page 73

Basic Procedure for Using the Loop Control Unit
2. Preparing Function Block Data (by CX-Process Tool)
4) Decide on the function block system configuration.
Analog input
AI 4-point/AO
4-point Terminal
Analog output
See Section 5 Examples of Function Block Combinations.
Refer to the Function Block Reference Manual.
5) Decide on the data to be monitored and manipulated by CX-Process
Monitor.
Refer to the CX-Process Monitor Operation Manual.
6) Assess the load rate and the external I/O refresh cycle.
See 1-2 Configuration of Instrumentation System.
See 3-2 Description of Operation.
7) Assess fail-safe countermeasures.
See 3-5 Fail-safe Countermeasure Guidelines.
1) Set up and start CX-Process Tool.
Prepare the function block
data on CX-Process Tool
running on the computer.
Refer to CX-Process Tool Operation Manual.
2) Set the System Common block data.
(For example, set the operation cycle and leading Data Memory address
for the Node Terminals.)
Refer to the Function Block Reference Manual.
3) In CX-Process Tool, wire the analog signals between the Selector blocks
(analog signals and accumulated value signals only).
Refer to the CX-Process Tool Operation Manual.
PV
Basic PID
Block
Model 011
MV
Section 1-5
53