Omron CS1W-LC001 Operation Manual page 71

How to Use Function Blocks for Specific Operations
To perform this specific operation
Constant Constant transmission of
setting/selec- constants as analog signals
tion
Setting of constants to specified
ITEMs under certain conditions
Selection of one of multiple
constants and transmission of
that constant as an analog signal
Analog signal Setting of analog signals to
setting/ specified ITEMs under certain
selection conditions
Selection of one of multiple
analog signals and transmission
of that analog signal as an analog
signal
Analog signal Selection of the maximum value
setting/ from multiple analog signals and
selection transmission of that maximum
value as an analog signal
Selection of the minimum value
from multiple analog signals and
transmission of that minimum
value as an analog signal
Selection of the nth largest value
from multiple analog signals and
transmission of the signal as an
analog signal
Switching of sensors on a
different measuring system or
measurement target
Switching of operation nodes on
a different measuring system or
measurement target
Changing two settings with a
ramp (e.g., opening and closing
valves)
Converting ranges of analog
signals merely by setting values
for 0% and 100% inputs and 0%
and 100% outputs
Analog Comparison of constant and
signal/ analog signals
constant
Comparison of two analog signals Use the Variable Comparator block (Block
comparison
Manipulation/ Manipulation and monitoring of
monitor/ ON/OFF valve with open/close
control of limit switches
special
Manipulation and monitoring of
external
motors
control target
Manipulation and monitoring of
reversible motors
Manipulation of a electric
positional-proportional motor as
the control target
Perform the following
Use the Constant Generator block (Block
Model 166).
Use the Constant Item Setting block (Block
Model 171).
Use the Constant Selector block (Block
Model 165).
Use the Variable ITEM Setting block (Block
Model 171).
Use the Input Selector block (Block Model
162).
Use the Rank Selector block (Block Model
161).
Use the 3-input Selector block (Block Model
163).
Use the 3-output Selector block (Block
Model 164).
Use the Ramped Switch block (Model Block
167).
Use the Range Conversion block (Block
Model 127).
Use the Constant Comparator block (Block
Model 202)
Model 203)
Use the ON/OFF Valve Manipulator block
(Block Model 221)
Use the Motor Manipulator block (Block
Model 222)
Use the Reversible Motor Manipulator block
(Block Model 223)
Use the Basic PID (Block Model 011)/
Advanced PID block (Block Model 012) and
Motor Opening Manipulator block (Block
Model 224)
Section 1-4
See page:
3-1 Configuration of
Function Blocks and
Function Block
Reference Manual
Function Block
Reference Manual
3-1 Configuration of
Function Blocks and
Function Block
Reference Manual
Function Block
Reference Manual
Function Block
Reference Manual
51