Omron CS1W-LC001 Operation Manual page 152

Exchanging Data with CX-Process Monitor/SCADA Software and with Other Nodes Section
Set at ITEM043 of
System Common
blocks
Leading address S →
Leading address S+24 →
Leading address S+536 →
Leading address S+636 →
Leading address S+736 →
Leading address S+3736 →
134
For details on how to use the Node Terminals that use the Controller Link
Data Link, see Appendix 2 How to Use the Node Terminal Block.
Note 2 The allocation locations of each of the areas (Area to send to computer, Area
to send to all nodes and Area to receive from all nodes) in Data Memory for
the Node Terminals are as follows:
Data Memory (D) for Node
Terminal
For LCU number 0
System
For LCU number 1
information
For LCU number 2
Area to send to computer
Area to send to all nodes
Area to receive from all nodes
8 words
8 words
24 words
8 words
512 words
(16 words x 32 blocks)
612 words
100 words
(2 words x 50 blocks)
100 words
(2 words x 50 blocks)
100 words
(2 words x 50 blocks)
100 words
(2 words x 50 blocks)
System information
+0 Unit address
+1 Loop Control Unit run status
+2 CPU Unit run status
+7 Data update check code
636 words
3-4