Omron CS1W-LC001 Operation Manual page 161

Simple Example of Use
144
4. Wire in the software the analog signals between blocks.
5. Set the ITEMs in each function block.
Set function block initial setting parameters (refer to the item "(S): Initial
setting data" describing how to read/write in the Function Block Reference
Manual) such as direct/reverse action and Set Point setting mode
(Remote/Local) on CX-Process Tool.
Operation-related parameters (refer to the item "(O): Operation Data"
describing how to read/write in the Function Block Reference Manual) such
as PID constants may be set either on CX-Process Tool or CX-Process
Monitor.
Section 4-1