Omron CS1W-LC001 Operation Manual page 10

xiv
Process Tool earlier than Ver.1.50 (Ver.1.00 or Ver. 1.20) are used. For
this reason, these function blocks cannot also be downloaded to the Loop
Control Unit.
If the following function blocks already exist on the Loop Control Unit and
are uploaded to CX-Process Tool, only the following function blocks are
not uploaded. (When a new upload is performed, these blocks become
empty.)
Segment Program (Block Model 157), Accumulated Value Input Adder (Block
Model 182), Accumulated Value Input Multiplier (Block Model 183), Constant
Comparator (Block Model 202), Variable Comparator (Block Model 203),
Clock Pulse (Block Model 207), ON/OFF Valve Manipulator (Block Model
221), Motor Manipulator (Block Model 222), Reversible Motor Manipulator
(Block Model 223), Motor Opening Manipulator (Block Model 224)
Likewise, the following functions can be used only when Loop Control Unit
CS1W-LC001 Ver.1.50 and onwards and CX-Process Tool Ver.1.50 and
onwards are used:
Á
The following ITEMs can be set on CX-Process Tool when versions of
Loop Control Unit earlier than Ver.1.50 (Ver.1.0
Process Tool Ver1.50 or onwards are used. However, if the data of these
ITEMs is downloaded to the Loop Control Unit when these ITEMs are set
on CX-Process Tool, only those ITEMs are not downloaded. (Other
ITEMs are downloaded successfully.)
The following ITEMs cannot be set on CX-Process Tool when Loop
Control Unit Ver.1.50 or onwards and versions of CX-Process Tool earlier
than Ver.1.50 (Ver.1.00 or Ver. 1.20) are used. For this reason, these
ITEMs cannot also be downloaded to the Loop Control Unit.
If a download in major item units (units of Loop Control Unit) or a
download in function blocks units including initial setting data is
performed, the respective defaults are set to the following ITEMs on the
Loop Control Unit.
If the following ITEMs are already set on the Loop Control Unit and are
uploaded to the CX-Process Tool, only the following ITEMs are not
uploaded.
AT (auto-tuning) functions of Basic PID block (Block Model 011) and
Advanced PID (Block Model 012), and wait function and additional steps
(step numbers 8 to 15) of the Ramp Program block (Block Model 155)
Note 1 For details on which actual ITEM this restriction applies to, refer to the ITEM
list for the relevant function block in the Function Block Reference Manual.
Note 2 The version of the Loop Control Unit can be verified in the Monitor run status
screen ([Execute]-[Run]-[Monitor run status]) on CX-Process Tool.
When the above function blocks are used, check in the Check System
Operation screen on CX-Process Tool beforehand that the content of ITEM
099 onwards in the System Common block (Block Model 000) is as follows.
ITEM
099
Data name
MPU/FROM version indication
Version V1.50 and onwards must be indicated.
or Ver.1.20) and CX-
Data
V1.50V1.50