Omron CS1W-LC001 Operation Manual page 198

Description of FINS Commands
181
Note 2 Specify the write start address, data length and write data for the number of
ITEMs.
Response format
Data format
Data length
(bytes)
When all ITEMs to be written can be written, and all ITEMs have been
written successfully, this shall be regarded as a normal completion.
Response code
Response code
0000 Hex
1001 Hex
1002 Hex
1003 Hex
1101 Hex
1103 Hex
110C Hex
Command code Response code
02 Hex 41 Hex MRES
1 1
Normal completion
Command length over
à The command length exceeds 2002 bytes.
Insufficient command length
à The command length is less than six bytes.
Number of elements/number of data mismatch
à The number of data items does not match the number of
ITEMs.
No type
à An unusable block address was specified in the parameter
type.
à The block address specified in the parameter type is an
unregistered function block.
à Function blocks other than System Common blocks cannot be
accessed as the RAM has not yet been initialized (cleared)
after a battery failure causes content of RAM to be lost.
Specified address out-of-range error
à The start address contains a non-existent ITEM.
à An attempt was made to write to the format setting of a
System Common block.
Other item parameter error
à Number of ITEMs is 0.
à The specified data length does not match the actual data of
each ITEM specified by the write start address.
à The combination of block address and block format is
forbidden.
à Write data is out of the data range for each ITEM.
SRES
1 1
Meaning
Section 6-3