Omron CS1W-LC001 Operation Manual page 65

Specifications
CX-Process Monitor Specifications
Item
Product name
Model
Applicable PC-series
Applicable Unit
Applicable Personal computer
computer
CPU
OS
Memory
Hard disk drive
Monitor
CD-ROM drive
Mouse
Sound board
Connecting Connection with CPU Unit
method (or Serial Communications
Board/Unit)
Connection via Controller
Link
Loop Control Unit data specification
method
Data exchange method with CPU Unit
mounted on Loop Control Unit
CX-Process
WS02-LCTC1
CS1 Series
Loop Control Unit
PC AT or compatible
Min. required: Pentium 133 MHz or faster, Recommended: Pentium MMX233
MHz or faster
Microsoft Windows NT4.0 Service Pack 4 or later or Windows 2000 (Windows
95/98 cannot be used.)
Min. required: 64 Mbytes, Recommended: 96 Mbytes or more
Min. required: 150 Mbytes of free space, Recommended: 200 Mbytes or more
of free space
Min. required: XGA, Recommended: XGA or higher, min. 1024 x 768 dots,
256 colors
At least one
Recommended: Microsoft mouse or compatible pointing device
1 pce.
When The computer is connected to the CPU Unit peripheral ports or
FinsGateway integrated RS-232C port, or RS-232C port of the Serial
SerialUnit Communications Unit. (Only a 1:1 connection is possible.)
version is - Connector cable:
used. When connecting to the CPU Unit peripheral ports: Model
CS1W-CN
When connecting to the CPU Unit's RS-232C port: Model
XW2Z-
(For details on model numbers, see 2-3 Connecting to CX-
Process Tool and CX-Process Monitor.
- Communications protocol with PC: Host Link (not supported
on Peripheral bus)
When The FinsGateway Controller Link version is installed on the
FinsGateway computer on which the Controller Link Support Board is
Controller mounted to enable communications with the PC on which the
Link version Controller Link Unit is mounted.
is used.
Function blocks, analog signals and contact signals (including parameters)
that are designated as the source by the Send to Computer blocks (Block
Models 401 to 404) are appended a tag number by the CX-Process Tool.
Specify this tag number to specify the Loop Control Unit data.
When reading from the Loop Control Unit:
Use the terminal to computer send area in the Data Memory for the node
terminals on the CPU Unit.
When performing operations on the Loop Control Unit:
Write to the function blocks that are specified as the source designation in the
Send to Computer block without using the terminal to computer send area.
Note: Microsoft Windows NT4.0 is required for preparing tag data to be used
by the CX-Process Monitor. This data cannot be prepared on Windows
95/98.
Mode name
On-demand read CX-Process Monitor reads the
mode: data in the terminal to
computer send area whenever
necessary.
Data Link mode: CX-Process Monitor reads the
terminal to computer send area
at all times by the Controller
Link data link.
Descriptions
(2 m, 6 m)
- (2 m, 5 m)
Description
Section 1-3
Connection method
One of Host Link,
Ethernet or Controller
Link
Only Controller Link is
possible
45