Table of Contents
Advertisement
Power supply
8.2 SIDOOR NT40
Procedure
Note
Risk of injury due to moving mechanical parts
The control system will become ready for operation after the supply line has been
connected. If a control signal is present, the door will move in the set direction.
Always connect the supply lines last of all!
Carry out the following steps in the given order:
1. Connect the controller to output line X2. Observe the polarity printed on the device.
2. Connect the supply line X1 to the supply network.
3. When the supply is switched on, the device is ready for operation.
The green LED lights up.
See Section Connection and commissioning (Page 137).
114
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
