Table of Contents
Advertisement
Controller
6.4 Operation and parameter assignment
Selecting a profile
1. Select the desired profile (1 to 6) by pressing the service button S402 (downwards) or
S403 (upwards).
2. Confirm the profile you have set by pressing and holding down the learn run button
(S401) until the dot lights up on the LED display (> 2 seconds).
The dot on the LED display indicates that the settings have been stored successfully.
Note
If the learn run button (S401) is pressed only briefly, the minimal editor switches to the
closing forces setting menu. The newly set profile is not saved.
48
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
