Table of Contents
Advertisement
Additional units
10.1 SIDOOR SERVICE TOOL
Operating principle
Action
1
2
3
4
5
Parameter changes
Note
Parameter changes are accepted with the door at a complete stop or in the OPEN or
CLOSED position.
Risk of injury due to moving mechanical parts
After parameters have been changed, the permitted energies and forces have to be
checked by service staff and adjusted if they exceed their limit values. This has to be done
on the heaviest door in the entire system with the shaft door and cabin door coupled.
Menu navigation
You can find a guide to the menus of the SIDOOR SERVICE TOOL in the section Navigation
structure (Page 52).
146
Select required parameter
Activate parameter for setting using the
Return key
Increase or decrease parameter value
Accept parameter value by pressing
Return key again
Select next parameter
•
Exit menu
•
WARNING
Key
Remarks
Parameter value flashes
Displayed parameter value stops
flashing after acceptance.
(See step 1)
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
