Table of Contents
Advertisement
General safety instructions
Parameter assignment and configuration
Risk of injury and material damage due to excessive closing force of the door
Exceeding the maximum static closing force may lead to injuries to persons or damage to
the door drive and mechanical components of the door.
After commissioning, have the maximum static closing force checked by the service
personnel, and adjusted to the limit value if it is excessive. The opening force is to be
limited to 150°N at glass doors. Observe the limit values of the applicable standards and
adjust the set values accordingly.
Note
Application-specific measures for emergency operation
In the event of a controller failure, measures must be taken for emergency operation
according to the application.
Modifications to the door drive
Loss of liability for defects and material damage
Changes to the door drive lead to the loss of liability for defects and compensation rights,
and the correct function of the door drive is no longer guaranteed.
Note the following rules:
• Do not make any modifications to the door drive (motor, controller, power supply).
• SIDOOR TRANSFORMER; SIDOOR NT40: Do not make a permanent connection as
• The power supply cord of the power supply (SIDOOR TRANSFORMER, SIDOOR
10
WARNING
CAUTION
this does not ensure a proper and required necessary disconnection from the mains. Do
not remove the protective Schuko-type socket under any circumstances (for example by
cutting it off).
TRANSFORMER UL or SIDOOR NT 40) cannot be replaced. Scrap the power supply if
the supply cable is damaged.
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
