Table of Contents
Advertisement
Display and buttons
Button
(LEARN
(OPEN)
(CLOSE)
Display
Activating the minimal editor
1. Disconnect the controller from the power supply by unplugging the power plug.
The line voltage can alternatively be connected and disconnected with the X3 connector
directly on the controller.
2. Press and hold down the S402 and S403 buttons simultaneously and reestablish the line
voltage by plugging the power plug back in. Continue to hold down both buttons.
3. An "8" appears on the LED display for approximately 5 seconds as confirmation.
4. Once the display stops, let go of both buttons within approximately 3 seconds. Do not
touch the buttons again during this time period.
5. To confirm the successful activation of the minimal editor, the LED display alternates
between a "C" and the currently assigned profile in the form of a number from 1 to 6.
ATE500E
System Manual, 09/2017, A5E33917696-AD
Function
Press for:
<2 s = switches between profile and counterweight settings
•
>2 s = saves the settings made (profile ↔ counterweight)
•
RUN)
Decreases a value (profile or counterweight)
Increases a value (profile or counterweight)
Description
Profile selection
Setting the closing force (counterweight)
1 ... 6 (under profile selection): Display of profile
•
0 ... 6 (under closing force): Display of counterweight
•
For additional information, see Profiles and adjustment ranges (Page 148).
6.4 Operation and parameter assignment
Controller
47
Advertisement
Table of Contents
