Table of Contents
Advertisement
Static cutter force CLOSE
This force serves to overcome the cutter distance in the closing direction.
A higher force is often required to overcome the cutter distance than for the rest of the
distance the door travels.
This parameter is effective in the closing direction when the door is within the cutter distance.
Adjustment ranges
The parameter can be adjusted in accordance with the adjustment ranges of the parameters
(see Section Profiles and adjustment ranges (Page 148)). The value of the parameter must
be selected so that the cutter distance is overcome in the closing direction.
Static nudge force CLOSE
This force is effective during the closing movement if a nudge command is present.
Adjustment ranges
The parameter can be adjusted in accordance with the adjustment ranges of the parameters
(see Section Profiles and adjustment ranges (Page 148)). The value of the parameter must
be selected so that, if a nudge command is present, the door moves across the entire door
width in the closing direction. Inadequate force can lead to an obstruction of the door.
Current – force – motor characteristic
The following characteristic shows the typical values for the MED280 motor in the opening
and closing directions. The actual force on the door may differ, and must be remeasured.
Figure 6-9
ATE500E
System Manual, 09/2017, A5E33917696-AD
Current – force – motor characteristic in the opening and closing directions
Controller
6.8 Parameters
81
Advertisement
Table of Contents
