Table of Contents
Advertisement
Connection and commissioning
Procedure
Preparing
1. Push the door into the CLOSED position.
2. Open the housing cover.
Connecting the motor
1. Connect the motor plug to slot X7.
Note
The X6 control inputs plug is not plugged in during commissioning in order to prevent
uncontrolled movements.
Connecting modules (optional, only for controllers with the corresponding module)
1. Connect the relay module.
Proceed as described in the Section Relay module (Page 66).
2. Connect the CAN module.
Proceed as described in the Section CAN module (Page 71).
138
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
