Table of Contents
Advertisement
Controller
6.6 Connecting terminals and interfaces
5. Secure the cables inside the plastic cover against being pulled out through the oval
aperture in the relay cover. Use cable ties for this purpose, tie each of them tightly round
the cable.
Ensure that the cable tie is tied so that at least 5 mm of the outer cable jacket lies inside
the protective cover.
6. Provide additional strain relief by attaching more cable ties to the fixing points provided in
the housing.
7. Slide the protective cover in the insertion direction back into its correct position.
8. Screw the fixing screw holding the protective cover on the relay module back in.
70
System Manual, 09/2017, A5E33917696-AD
ATE500E
Advertisement
Table of Contents
