Thickness - Omron ZX2-LDA41 User Manual

Thickness

Procedure for setting up thickness
The Amplifier Units to set up differ for each menu. Note also that different channels are
used to specify each menu item, as shown below.
Sensor installation/wiring
Set to the MENU mode
Mutual interference prevention
Response time setting
Smart tuning
1
Sensor installation/wiring
Has the Sensor been installed and wired? (See page 23.)
Connect two Amplifier Units with a Calculating Unit in between. (The calculation
result is displayed and output on the CH2 Amplifier Unit.)
Set up the two Sensor Heads so that they are facing each other, adjust the
positions of the Sensor Heads while looking at the digital display values on the
Amplifier Units or the indicators on the Sensor Heads so that the clearance
between the sensing object and each Sensor Head is near the measurement
center distance, and install the Sensor Heads at these positions.
Prepare a reference sensing object of known thickness.
2
Set to the MENU mode
(Use CH1 and CH2 for these settings.)
Button
Display
Operation
Hold down for
3 seconds
ZX2 User's Manual
2-sensor operation (thickness)
CH1
CH2 Hold
CH1
Trigger conditions
CH1
Threshold setting
CH1 Return to RUN mode
Setting completed
Required
Required
Description of Operation
Hold down the
Lit
three seconds to switch to the
MENU mode.
CH2
Other than
CH2
OFF
CH2
CH1
CH2
Select the desired mode to set
the measurement conditions in.
Explanation of
Selection Menu
button for
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
Required setting
MAIN
APPLICATIONS
Optional setting
& SETTING
METHODS
Height
Steps
and
CH1
Warpage
CH2
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
57
Thickness