Omron ZX2-LDA41 User Manual page 78

8
Threshold Setting
Button
Operation
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
[Change numeric value]
BASIC
SETUP
Press to set.
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
[Change numeric value]
Positioning
Eccentricity
Press to set.
and Surface
Deflection
DETAILED
SETTINGS
9
Return to RUN mode
TROUBLE-
SHOOTING
Button
Operation
SPECIFI-
CATIONS
INDEX
Hold down for
3 seconds
* For details on optimizing settings, such as output and input, see "DETAILED
SETTING
TRANSITION
SETTINGS."
CHARTS
78
Eccentricity and Surface Deflection
Required
Display Description of Operation
Press the
the HIGH threshold.
Lit
Press the
setting of the HIGH threshold.
Press the
the digit, press the
change the numeric value, and
Set any value.
set the HIGH threshold.
Press the
the setting.
Press the
the LOW threshold.
Lit
Press the
setting of the LOW threshold.
Press the
the digit, press the
change the numeric value, and
Set any value.
set the LOW threshold.
Press the
the setting.
Required
Display Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
Set the range of measured values to be judged as
PASS by setting the HIGH and LOW thresholds.
button to display Setting example:
Non-defective product
eccentricity -1 to 1 mm
button to enable
button to move
button to
Set the eccentricity MAX and
MIN distances to be
regarded as OK to the HIGH
button to apply and LOW thresholds,
respectively.
button to display
* If the
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
button to enable
the setting will be canceled.
* Set so that the HIGH
threshold is greater than the
button to move
LOW threshold.
button to
button to apply
Switch to the mode in which measurement
is performed.
button for
Explanation of
Selection Menu
1 mm
-1 mm
H
P
L
button is pressed
Explanation of
Selection Menu
ZX2 User's Manual