Omron ZX2-LDA41 User Manual page 71

6
Threshold Setting
Button
Display
Operation
Lit
[Change numeric value]
Set any value.
Press to set.
Lit
P di l
[Change numeric value]
Set any value.
Press to set.
7
Return to RUN mode
Button
Display
Operation
Hold down for
3 seconds
* For details on optimizing settings, such as output and input, see "DETAILED
SETTINGS."
ZX2 User's Manual
Set the range of measured values to be judged as
PASS by setting the HIGH and LOW thresholds.
Required
Description of Operation
Press the button to display
the HIGH threshold.
Press the button to enable
setting of the HIGH threshold.
Press the button to move
the digit, press the
change the numeric value, and
set the HIGH threshold.
Press the button to apply
the setting.
Press the button to display
the LOW threshold.
Press the button to enable
setting of the LOW threshold.
Press the button to move
the digit, press the
change the numeric value, and
set the LOW threshold.
Press the button to apply
the setting.
Required
Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
Explanation of
Selection Menu
Setting example:
Non-defective product
position 49 to 51 mm
H
Set the positioning MAX and
MIN distances to the HIGH
button to
and LOW thresholds,
respectively.
* If the
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
* Set so that the HIGH
threshold is greater than the
LOW threshold.
button to
Switch to the mode in which measurement
is performed.
Explanation of
Selection Menu
button for
P L
51 49
button is pressed
Positioning
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
71