Omron ZX2-LDA41 User Manual page 60

6
2-sensor operation (thickness)
(Use CH2 for these settings.)
CONTENTS Button
Operation
INTRODUCTION
PREPARATION
—
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Press to select
Steps
and
Warpage
Double
Sheet
[Change numeric value]
Detection
Thickness
Press to set.
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
60
Thickness
Display Description of Operation
Set the reference sensing object
of which thickness is known in
place.
—
Press the
Amplifier Unit to display
Press the
Press the
the thickness setting.
Press the
the digit, press the
change the numeric value, and
set the thickness numeric value.
Set any value.
Press the
the setting.
Make this initial setting to measure thickness
when using two Sensor Head to measure
Required
thickness.
button on the CH2
.
button to display
.
button to apply
button to move
button to
button to apply
Explanation of
Selection Menu
Calculating Unit
CH2
(Calculation result is output.)
to
* If the button is pressed
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
* The 2-sensor operation
reference value is determined
based on the measured values
of CH1 and CH2 by the timing
that setting of the thickness
numeric values is executed.
* For details on the response
time when connecting two or
more Amplifier Units, see page
.
86
ZX2 User's Manual
CH1