Eccentricity And Surface Deflection - Omron ZX2-LDA41 User Manual

Eccentricity and Surface Deflection

CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
Procedure for setting up eccentricity and surface deflection
FLOW OF
OPERATION
Sensor installation/wiring
Set to the MENU mode
BASIC
SETUP
Response time setting
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
1
and
Warpage Sensor installation/wiring
Double
Has the Sensor been installed and wired? (See page 23.)
Sheet
Detection
Set the sensing object in place, adjust the position of the Sensor Head while
looking at the digital display values on the Amplifier Unit or the indicators on the
Thickness
Sensor Head so that the clearance between the Sensor Head and the sensing
object is near the measurement center distance, and install the Sensor Head at this
position.
Positioning
2
Eccentricity
Set to the MENU mode
and Surface
Deflection
Button
Operation
DETAILED
SETTINGS
TROUBLE-
Hold down for
3 seconds
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
Press to display.
CHARTS
72

Eccentricity and Surface Deflection

Smart tuning
Scaling
Display
Hold down the
Lit
three seconds to switch to the
MENU mode.
Press the
Press the
display to
the detail menu.
Hold
Trigger conditions
Threshold setting
Return to RUN mode
Setting completed
Required
Select the desired mode to set
Required
the measurement conditions in.
Description of Operation
button for
button to display
.
button to set the
to set display of
Other than
OFF
Required setting
Optional setting
Explanation of
Selection Menu
* This operation is not
required when scaling, hold
and trigger conditions are not
to be set.
ZX2 User's Manual