Double Sheet Detection - Omron ZX2-LDA41 User Manual

Double Sheet Detection

CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
Procedure for setting up double sheet detection
FLOW OF
OPERATION
Sensor installation/wiring
BASIC
Set to the MENU mode
SETUP
MAIN
Response time setting
APPLICATIONS
& SETTING
METHODS
Height
Steps
1
and
Sensor installation/wiring
Warpage
Double
Has the Sensor been installed and wired? (See page 23.)
Sheet
Set the reference workpiece in place, adjust the position of the Sensor Head while
Detection
looking at the digital display values on the Amplifier Unit or the indicators on the
Sensor Head so that the measured value at measurement of one product and at
Thickness
measurement of two products is within the measurement range, and install the
Sensor Head at this position.
Positioning
2
Set to the MENU mode
Eccentricity
and Surface
Deflection
Button
Operation
DETAILED
SETTINGS
Hold down for
3 seconds
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
Press to display.
CHARTS
52

Double Sheet Detection

Smart tuning
Required
Display Description of Operation
Hold down the
Lit
three seconds to switch to the
MENU mode.
Press the
Press the
display to
the detail menu.
Hold
Trigger conditions
Threshold setting
Return to RUN mode
Setting completed
Required
Select the desired mode to set
the measurement conditions in.
button for
button to display
.
button to set the
to set display of
Other than
OFF
Required setting
Optional setting
Explanation of
Selection Menu
* This operation is not
required when hold and
trigger conditions are not to
be set.
ZX2 User's Manual