Omron ZX2-LDA41 User Manual page 92

2
Hysteresis width setting
Button
Operation
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
Press to display.
OPERATION
[Change numeric value]
BASIC
SETUP
Press to set.
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
3
and
Return to RUN mode
Warpage
Double
Sheet Button
Detection
Operation
Thickness
Hold down for
3 seconds
Positioning
Important
Eccentricity
and Surface
• The hysteresis width for HIGH, PASS or LOW judgment is disabled when the hold function is
Deflection
enabled.
• The hysteresis width is enabled when the self-trigger is set.
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
92
Setting the Hysteresis
Display Description of Operation
Press the
.
Press the
setting of the hysteresis width.
Press the
the digit, press the
change the numeric value, and
set the hysteresis width.
Set any value.
Press the
the setting.
Display Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
button to display
button to enable
button to move * If the
button to when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
button to apply
button for
Explanation of
Selection Menu
Default value: 0.000
button is pressed
Explanation of
Selection Menu
ZX2 User's Manual