Omron ZX2-LDA41 User Manual page 51

Button
Display
Operation
[Change numeric value]
Set any value.
Press to set.
Lit
[Change numeric value]
Set any value.
Press to set.
8
Return to RUN mode
(Use CH1 and CH2 for these settings.)
Button
Display
Operation
Hold down for
3 seconds
* For details on optimizing settings, such as output and input, see "DETAILED
SETTINGS."
ZX2 User's Manual
Description of Operation
Press the button to enable
setting of the HIGH threshold.
Press the button to move
the digit, press the
change the numeric value, and
set the HIGH threshold.
Press the button to apply
the setting.
Press the button to display
the LOW threshold.
Press the button to enable
setting of the LOW threshold.
Press the button to move
the digit, press the
change the numeric value, and
set the LOW threshold.
Press the button to apply
the setting.
Required
Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
Explanation of
Selection Menu
* If the
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
button to the setting will be canceled.
* Set so that the HIGH
threshold is greater than the
LOW threshold.
button to
Switch to the mode in which measurement
is performed.
Explanation of
Selection Menu
button for
Steps and Warpage
button is pressed
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
SETTING
TRANSITION
CHARTS
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
INDEX
51