Omron ZX2-LDA41 User Manual page 145

Bank input
• When only one Amplifier Unit is used
Example: Switching from bank 2 to bank 1
Bank input 0 (purple)
Bank input 1 (red)
Bank
(*) Bank input is executed by the ON/OFF combinations of BANK input 0 and BANK input 1.
If a bank input signal is input for 4 ms or more, the bank is determined, the bank is switched within
20 ms, and then measurement is resumed.
Acquire the measurement results after the preset response time elapses.
• When connecting two or more Amplifier Units
Example: Switching from bank 2 to bank 1
Bank input 0 (purple)
Bank input 1 (red)
Banks of
CH2 or later
(*) Bank input is executed by the ON/OFF combinations of CH1 BANK input 0 and CH1 BANK
input 1 when connecting two or more Amplifier Units.
If a CH1 bank input signal is input for 4 ms or more, the bank is determined, the bank is switched
within 50 ms if mutual interference prevention is set to OFF, and within 420 ms if mutual
interference prevention is set to ON, and then measurement is resumed.
Acquire the measurement results after the response time specified for connecting two or more
Amplifier Units elapses.
ZX2 User's Manual
ON
OFF
ON
OFF
Bank 2
ON
CH1
OFF
ON
CH1
OFF
CH1
Bank
(See page 86.)
Bank 2
4 ms
Within
or more 20 ms
Bank 1
Bank switching
Bank 2
4 ms
or more
When mutual interference prevention is
set to OFF: Within 50 ms
When mutual interference prevention is
set to ON: Within 420 ms
Bank 2
Bank switching
Bank 2
Bank switching
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
Bank 1 DETAILED
SETTINGS
Bank 1 TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
145
Timing Charts