Steps And Warpage - Omron ZX2-LDA41 User Manual

Steps and Warpage

Procedure for setting up steps and warpage
The Amplifier Units to set up differ depending on whether mutual interference prevention
is set to ON or OFF.
Note that different channels are used to specify each menu item, as shown below.
Sensor installation/wiring
Set to the MENU mode
Mutual interference prevention
Response time setting
ON: Mutual interference prevention is ON
OFF: Mutual interference prevention is OFF
1
Sensor installation/wiring
Has the Sensor been installed and wired? (See page 23.)
Connect two Amplifier Units with a Calculating Unit in between. (The calculation
result is displayed and output on the CH2 Amplifier Unit.)
Set the reference workpiece in place, adjust the position of the Sensor Head while
looking at the digital display values on the Amplifier Unit or the indicators on the
Sensor Head so that each of the heights to be measured is near the measurement
center distance, and install the Sensor Head at this position.
2
Set to the MENU mode
(Use CH1 and CH2 for these settings.)
Button
Display
Operation
Hold down for
3 seconds
ZX2 User's Manual
Smart tuning
CH1, CH2 (ON)
2-sensor operation (A-B)
CH1, CH2 (OFF)
CH1 (ON)
Threshold setting
CH1 (ON)
Return to RUN mode
CH1, CH2 (OFF)
Setting completed
Required
Required
Description of Operation
Hold down the
Lit
three seconds to switch to the
MENU mode.
CH1 (ON)
CH1, CH2 (OFF)
CH2 (ON)
CH2 (OFF)
CH2 (ON)
CH2 (OFF)
CH1, CH2 (ON)
CH1, CH2 (OFF)
Select the desired mode to set
the measurement conditions in.
Explanation of
Selection Menu
button for

Steps and Warpage

CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
Required setting
MAIN
APPLICATIONS
& SETTING
Optional setting
METHODS
CH1
CH2
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
47
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection