Omron ZX2-LDA41 User Manual page 89

2
Mutual interference prevention setting
Button
Display
Operation
Press to display.
3
Return to RUN mode
Button
Display
Operation
Hold down for
3 seconds
Important
• When CH1 is used to specify a setting while mutual interference prevention is set to ON, the
menus for which the same setting is applied to the Amplifier Units of CH2 and later are
shown in the following table.
Specify settings for the menus in the following table after setting mutual interference
prevention to ON.
Menu
Response time setting
Smart tuning
• When connecting two or more Amplifier Units, the response times (maximum values) are as
follows:
Mutual Interference
Prevention
OFF
ON
ZX2 User's Manual
Description of Operation
Press the button to display
.
Press the button to display
.
Press the
the setting.
Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
Displayable and
Specifiable CH Number
CH1
CH1
Two-Sensor
Operation
OFF
(A – B), THICK
OFF
(A – B), THICK
button to apply
button for
The setting of CH1 is also applied to Amplifier Units of
CH2 and later.
Smart tuning for the Amplifier Units of CH2 and later
are executed together with CH1.
Total Response Time
Response time setting for each CH
(Total response time setting for each CH) +
(4 ms × number of connected units)
(Response time per unit in the table below) ×
number of connected units
Mutual Interference Prevention
Explanation of
Selection Menu
Default value: OFF
Explanation of
Selection Menu
Notes
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
89