Job Step No. Saving Function - YASKAWA DX200 Instructions Manual

Pendant Oscilloscope
Function
4.3
4 Other Functions

4.3 Job Step No. Saving Function

Job Step No. Saving Function
When "1" is set to S2C1242, the job step No. saving function is enabled.
In this function, the job name and the step No. which are under execution
at the time are added to the waveform data of the CSV file, and the
waveform data and the job step No. are related and saved.
The job step No. saving function is available in the version
NOTE
DN1.61.00A(--)-00 and the later.
Fig. 4-4: Example for Adding Items to Be Saved in CSV File (Job Name
and Step No.)
The job name and the step No. are saved only when the play mode
executes a job and when the teach mode executes a trial run or a NEXT
operation. In a JOG operation or an IO jog operation, the job name and
the step No. are not saved.
Table 4-3: Conditions that Job Name and Step No. Are Saved
Operation
Playback
Trial run
Interlock + NEXT
NEXT
NEXT for P variable
IO jog
Jog operation
The job name and the step No. are assigned to the position
instruction. On the other hand, the waveform data interprets
the position instruction and acquires data when the motor
NOTE
operates actually. Therefore, deviations of acquisition timing
for a certain time occurs between both data.
Be careful when referring to the data which is close to the
switching point of the step No.
4-6
165467-1CD
Saved/not
Saved
Saved
Saved
Saved
Not
Not
Not
HW1481803
38 of 48