YASKAWA DX200 Instructions Manual page 25

165467-1CD
Pendant Oscilloscope
Function
2 Setting and Operation for Data Measurement
2.3 Setting Measurement Conditions
 Level
Specify the trigger level by the vertical division (-10.0 to +10.0).
The current trigger level is shown by a marker on the left of the
waveform display area (see Fig. 2-11).
The marker shape depends on the selected trigger type.
Fig. 2-11: Trigger Level Marker
Trigger level
marker
The value specified here is regarded as a position with the
zero point of trigger target channel as reference. When the
NOTE trigger level is specified as 2.5 [div] with the channel zero
position of -2.0 [div] (in vertical axis), the displayed position
of trigger level on the waveform display area is 0.5 [div] (in
vertical axis). (See the example of Fig. 2-9.)
 TriggerMode
Switches the valid/invalid state of trigger. According to this setting, the
waveform data acquisition mode is switched.
• Invalid: Continuous mode
When the waveform data measurement is started, the acquired data is
continuously displayed in a time-series order.
• Valid: Trigger mode
The measurement is automatically stopped when the trigger conditions
are satisfied, and the waveform is displayed.
○When {Alarm} is selected as TrigType:
When {Alarm} is selected as the trigger type, the only condition for the
trigger is when the target alarm specified
here by the number occurs. The alarm trigger does not depend on the
channel setting, so the settings of {CH} or {Level} are not referred.
2-13
25 of 48
HW1481803