Main Screen Configuration - YASKAWA DX200 Instructions Manual

Pendant Oscilloscope
Function
2.2
2.2.1 Main Screen (Not In-measurement Mode)
Name

Waveform display area

{MINIMIZE} button
 {CH} button
 {START} button
 {CLEAR} button

{CLOSE} button

Condition setting panel

Maximum display value

Minimum display value

Reference unit
2 Setting and Operation for Data Measurement

2.2 Main Screen Configuration

Main Screen Configuration
Here explains the configuration of the Main screen.
The PP oscilloscope is displayed on the entire screen of Programming
Pendant. The main screen has two types of modes; in-measurement and
without not in-measurement (Waiting), in which functions or availability of
some buttons are changed.
Condition setting is only available in not in-measurement mode (Waiting).
Main screen of not in-measurement mode (Waiting) is shown in Fig. 2-2
below with description.
Fig. 2-2: Main Screen (Not In-measurement Mode)
Function
Displays measured data waveform. When the data is not yet acquired soon
after the startup or when the data is cleared, nothing is shown here.
At the upper left of the area, measurement value obtained by the cursor
measurement function is displayed.
Minimizes the PP oscilloscope application.
Opens the Channel Setting window. (For details of the Channel Setting
window, refer to section 2.3.1 "Channel Setting Window" on page 2-4)
Starts the data measurement.
Deletes the displayed data waveform.
Terminates the PP oscilloscope.
Enables to set various conditions. Touching the upper tab enables to open
the setting screen corresponding to each parameter. (For details of each
condition setting, refer to section 2.3.2 "CH Display Setting Panel" on page 2-
8 to section 2.3.4 "Trigger Setting Panel" on page 2-11.)
Displays values and units at the uppermost of waveform display area by each
channel.
Displays values and units at the lowermost of waveform display area by each
channel.
Displays the reference unit by each channel. For details of the reference unit,
refer to section 5.2 "Reference Unit" on page 5-2.
On the Main screen, information by channels is displayed in each specific
color; for example in Fig. 2-2, information on CH3 is displayed in green,
where the reference unit is 50%/div, the maximum display value is 450%,
and the minimum display value is -50%.
2-2
165467-1CD
HW1481803
14 of 48