Setting And Operation For Data Measurement - YASKAWA DX200 Instructions Manual

165467-1CD
Pendant Oscilloscope
Function
2

Setting and Operation for Data Measurement

2.1
2 Setting and Operation for Data Measurement
2.1 Startup of Pendant Oscilloscope Function
This chapter describes setting and operation required for the
measurement.
Basically the PP oscilloscope is operated by touching on the screen; for
pull-down selection box or entry box,
however, the Cursor Keys enable the cursor operation, and [SELECT],
[ENTER] or [CANCEL] key enables selection, determination, or cancel,
just as the normal operation on the pendant screens.
In performing numerical input using an entry box, first activate the
parameter to a selective state by [SELECT] key, input numerical values by
the Number Keys of the pendant, and press [ENTER] key to determine it.
To cancel the input numerical values, press [CANCEL] key in the selective
state.
Startup of Pendant Oscilloscope Function
The PP oscilloscope can be started up by the following step:
1. Select {ROBOT} from the menu in the left of screen.
2. Select {PENDANT OSCILLOSCOPE} from the expanded menu (see
Fig. 2-1).
Fig. 2-1: PP Oscilloscope Startup Menu
2-1
13 of 48
HW1481803