Using The Board Test System; The Configure Menu - Intel Stratix 10 GX User Manual

6 Board Test System
To run the BTS
1. Navigate to the
run the
2. A GUI appears, displaying the application tab corresponding to the design running
in the FPGA. If the design loaded in the FPGA is not supported by the BTS GUI,
you will receive a message prompting you to configure your board with a valid BTS
design. Refer to the Configure Menu for information on configuring your board.

6.3 Using the Board Test System

This section describes each control in the Board Test System.

6.3.1 The Configure Menu

Use the Configure Menu to select the design you want to use. Each design example
tests different functionality that corresponds to one or more application tabs.
Figure 16. The Configure Menu
<package dir>\examples\board_test_system
BoardTestSystem.exe
®
Intel Stratix
application.
®
10 GX Transceiver Signal Integrity Development Kit User Guide
directory and
49