Power Monitor - Intel Stratix 10 GX User Manual

6 Board Test System
Data Rate (H-Tile): Displays the XCVR type and data rate of each channel.
Figure 35. CFP4 Data Rate
Tx (Mbps) and Rx (Mbps): Show the number of bytes of data analyzed per second.

6.3.12 Power Monitor

The Power Monitor measures and reports current power information and
communicates with the MAX V device on the board through the JTAG bus. A power
monitor cicruit attached to the device allows you to measure the power that the FPGA
is consuming.
To start the application, click the Power Monitor icon in the BTS. You can also run the
Power Monitor as a stand-alone application. The
<package dir>\examples\board_test_system
Note: You cannot run the stand-alone power application and BTS at the same time. Also, you
cannot run power and clock interface at the same time.
Note: Intel recommends to remove R494 resistor from the board if VCC total current is less
than 36 A. Reserve R494 if VCC total current is larger than 36 A.
® ®
Intel Stratix 10 GX Transceiver Signal Integrity Development Kit User Guide
resides in the
PowerMonitor.exe
directory.
81