Intel Stratix 10 GX User Manual page 53

6 Board Test System
Figure 19. The Flash Tab
The following sections describe the controls on the Flash tab.
Read
The Read control reads the flash memory on your board. To see the flash memory
contents, type a starting address in the text box and click Read. Values starting at the
specified address appear in the table. The flash memory sits at the base address of
0x1000.0000
values starting at this address are displayed. Valid entries are
0x0FFF.FF80
Note:
If you enter an address outside of
address space, a warning message identifies the valid flash memory address range.
Write
The Write control writes the flash memory on your board. To update the flash memory
contents, change values in the table and click Write. The application writes the new
values to flash memory and then reads the values back to guarantee that the
graphical display accurately reflects the memory contents.
Note: To prevent overwriting the dedicated portions of the flash memory, the application
limits the writable flash memory address range to
corresponds to address range
of the user software memory block).
. To see flash memory contents, type the address above the base and
.
0x0000.0000
0x0000.0000
® ®
Intel Stratix
to
0x0FFF.FFFF
0x0FF80000
- in the uppermost portion
0x00080000
10 GX Transceiver Signal Integrity Development Kit User Guide
through
0x0000.0000
flash memory
- (which
0x0FFFFF80
53