Configuration Example - HP FlexNetwork MSR Series Configuration Manual

Configuration example

Enable call waiting for the voice subscriber line of Telephone A. Place a call from Telephone C to
Telephone A, which is in a conversation with Telephone B. The subscriber at Telephone A hears call
waiting tones, and Telephone C is not rejected but waits for Telephone A to answer the new call.
# Enable call waiting for the voice subscriber line of Telephone A.
<Sysname> system-view
[Sysname] subscriber-line 1/0
[Sysname-subscriber-line1/0] call-waiting enable
Configuring call hold
This section describes how to enable call hold and configure the tone playing mode.
Configuration prerequisites
The router is equipped with an FXS voice interface card.
Enabling call hold using command lines
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Enable call hold.
NOTE:
This command is applicable only for the FXS voice subscriber line.
Configuring the tone playing mode for call hold
There are two tone playing modes for call hold:
•
inactive—Silent mode. In this mode, the calling party does not play any tones to the called
party during call hold.
•
sendonly—Playing mode. In this mode, the calling party plays the specified tones to the called
party during call hold. Before specifying the playing mode for call hold, you need to configure
the media resource. For more information about media resource configuration, see
"Configuring customizable IVR."
If you specify sendonly as the tone playing mode for call hold, you can specify the tones played to
the called party using one of the following methods:
•
Specify the media resources ID. During call hold, the calling party plays the specified tones to
the called party. Before specifying the playing mode for call hold, you need to configure the
media resource. For information about media resource configuration, see "Configuring
customizable IVR."
•
Specify the MoH number. During the call hold, the third party (the music server) plays the tones
to the called party according to the MoH number. This method is available only when the device
operates as the SIP trunk device. For more information about SIP trunk, see "Configuring SIP
Command
system-view
subscriber-line line-number
call-hold enable
232
Remarks
N/A
N/A
Disabled by default.