HP FlexNetwork MSR Series Configuration Manual page 330

Configuring VoFR packets to carry a timestamp
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoFR entity view.
5. Configure a match template
for the VoFR entity.
6. Configure VoFR packets to
carry a timestamp.
Configuring nonstandard-compatible mode
Configuration prerequisites
Before configuring nonstandard compatible VoFR, complete the following tasks:
•
Configure POTS entities.
•
Configure VoFR entities.
Configuring a call mode
For details, see
Configuring a call control protocol
Step
1. Enter system view.
2. Enter serial interface view.
3. Specify the link layer
protocol for interface
encapsulation as frame
relay.
4. Enter interface DLCI view.
5. Specify the VoFR call control
protocol on DLCI as
nonstandard-compatible.
Configuring CID selection mode
For details, see
Configuring VoFR packets to carry a sequence number
The terminating voice gateway determines whether there is any voice packet loss, duplicate voice
packets, or out-of-sequence occurs according to sequence numbers. This helps for voice quality.
Command
system-view
voice-setup
dial-program
entity entity-number vofr
match-template match-string
timestamp
"Configuring a call mode."
Command
system-view
interface serial interface-number
link-protocol fr [ ietf |
nonstandard ]
fr dlci dlci-number
vofr nonstandard-compatible
signal-channel ccid-no
data-channel dcid-no
[ keepalive ]
"Configuring a CID selection mode."
317
Remarks
N/A
N/A
N/A
N/A
By default, no match template is
configured for the VoFR entity.
Optional.
By default, voice packets do not
carry any timestamp.
Note that only the call control
protocol in the Huawei-compatible
mode supports the timestamp
function.
Remarks
N/A
N/A
By default, the link layer protocol
for interface encapsulation is
PPP.
N/A
By default, no VoFR call control
protocol is supported.