HP FlexNetwork MSR Series Configuration Manual page 90

Step
3. Create a TS set and enable
R2 signaling for it.
4. Enter R2 CAS view.
5. Configure the trunk direction
for R2 signaling.
Enabling the terminating side to send busy tones to the calling subscriber
Step
1. Enter system view.
2. Enter E1/T1 interface view.
3. Create a TS set and enable
R2 signaling for it.
4. Enter R2 CAS view.
5. Enable the terminating side
to send busy tones to the
calling subscriber.
6. Configure the duration of
playing busy tones.
Enabling the DTMF mode to receive and send R2 signaling
Step
1. Enter system view.
2. Enter E1/T1 interface view.
3. Create a TS set and enable
R2 signaling for it.
4. Enter R2 CAS view.
5. Enable the receiving and
sending of R2 signaling in
the DTMF mode.
6. Configure the delay before
sending DTMF signals.
Command
timeslot-set ts-set-number
timeslot-list timeslots-list signal
r2
cas ts-set-number
trunk-direction timeslots
timeslots-list { dual | in | out }
Command
system-view
controller { e1 | t1 } slot-number
timeslot-set ts-set-number
timeslot-list timeslots-list signal
r2
cas ts-set-number
sendring ringbusy enable
timer ring { ringback |
ringbusy } time
Command
system-view
controller { e1 | t1 } slot-number
timeslot-set ts-set-number
timeslot-list timeslots-list signal
r2
cas ts-set-number
dtmf enable
timer dtmf time
77
Remarks
N/A
N/A
Optional.
Bidirectional by default.
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, the terminating side
sends busy tones to the calling
subscriber.
Optional.
By default, the duration of playing
busy tones is 30,000
milliseconds.
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, R2 signaling is
received and sent in the
multi-frequency compelled (MFC)
mode.
Optional.
The default is 50 milliseconds.
You must configure the dtmf
enable command before this
command.