HP FlexNetwork MSR Series Configuration Manual page 111

# Configure a target match-template for the VoIP voice entity.
[RouterA-voice-dial-entity755] match-template 0755....
# Configure the target address of the VoIP voice entity.
[RouterA-voice-dial-entity755] address sip ip 2.2.2.2
2. Configure Router B:
# Configure the IP address 2.2.2.2/24 for the interface Ethernet 2/1.
<RouterB> system-view
[RouterB] interface ethernet 2/1
[RouterB-Ethernet2/1] ip address 2.2.2.2 255.255.255.0
[RouterB-Ethernet2/1] quit
# Create an ISDN PRI group on interface E1 1/1.
[RouterB] controller e1 1/1
[RouterB-E1 1/1] pri-set
[RouterB-E1 1/1] quit
# Set the ISDN protocol type and protocol mode for the ISDN interface serial 1/1:15.
[RouterB] interface serial 1/1:15
[RouterB-Serial1/1:15] isdn protocol-type qsig
[RouterB-Serial1/1:15] quit
# Create a POTS voice entity for the ISDN PRI interface.
[RouterB] voice-setup
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 2001 pots
# Configure a target match-template pointing to telephone number 0755-2001 for the POTS
voice entity.
[RouterB-voice-dial-entity2001] match-template 07552001
# Associate the POTS voice entity with subscriber line 1/1:15.
[RouterB-voice-dial-entity2001] line 1/1:15
[RouterB-voice-dial-entity2001] send-number all
[RouterB-voice-dial-entity2001] quit
[RouterB-voice-dial] quit
# Enable the QSIG tunneling function on the subscriber line associated with the POTS voice
entity.
[RouterB] subscriber-line 1/1:15
[RouterB-subscriber-line1/1:15] qsig-tunnel enable
[RouterB-subscriber-line1/1:15] quit
# Create a VoIP voice entity.
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 010 voip
# Configure a target match-template for the VoIP voice entity.
[RouterB-voice-dial-entity10] match-template 010....
# Configure the target address of the VoIP voice entity.
[RouterB-voice-dial-entity10] address sip ip 1.1.1.1
98