Configuring A Dial Terminator; Number Match Mode Configuration Example - HP FlexNetwork MSR Series Configuration Manual

When a subscriber dials 0106688#, if you configure the router to use longest match mode and
the dial terminator "#" on the router, the router will as well ignore the configured longest match
mode and use shortest match mode to establish a call connection.
To configure a global number match mode:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Configure a global number
match mode.

Configuring a dial terminator

In areas where variable-length numbers are used, you can specify a character as the dial terminator
so that the voice gateway can dial out the number before the dialing interval expires. The dial
terminator identifies the end of a dialing process, and a call connection will be established based on
the received digits when the dial terminator is received. The voice gateway will not wait for further
digits even if the longest match mode has been globally configured.
To configure a dial terminator:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Configure a dial terminator.

Number match mode configuration example

Figure 28
and the following describe the configurations for different number match modes on Router
A and Router B:
Command
system-view
voice-setup
dial-program
number-match { longest |
shortest }
Command
system-view
voice-setup
dial-program
terminator character
106
Remarks
N/A
N/A
N/A
By default, the shortest match
mode is adopted.
Remarks
N/A
N/A
N/A
Optional.
By default, no dial terminator is
configured.
If you set the argument character
to # or *, and if the first character
of the configured entity number is
the same as the argument
character (# or *), the device will
take this first character as a
common number rather than a
dial terminator.