HP FlexNetwork MSR Series Configuration Manual page 163

Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Specify TLS as the global
transport layer protocol for
outgoing SIP calls.
To specify TLS as the transport layer protocol for outgoing SIP calls on a VoIP voice entity:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter VoIP voice entity view.
5. Specify TLS as the transport
layer protocol for outgoing
SIP calls.
NOTE:
The transport layer protocol configured on two communication parties must be the same. That is, if
you execute the transport tls command on the sender device, you need to execute the listen
transport tls command on the receiver device.
To specify TLS as the transport layer protocol for incoming SIP calls:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Specify TLS as the transport
layer protocol for incoming
SIP calls.
To set the aging time for TLS connection:
Command
system-view
voice-setup
sip
transport tls
Command
system-view
voice-setup
dial-program
entity entity-number voip
transport tls
Command
system-view
voice-setup
sip
listen transport tls
150
Remarks
N/A
N/A
N/A
By default, UDP is adopted.
Remarks
N/A
N/A
N/A
N/A
By default, the global transport
layer protocol is UDP, and no
transport layer protocol is
specified for a VoIP voice entity.
If the transport layer protocol is
not specified for a VoIP voice
entity, the global setting is
applied.
This command is effective only
when the type of the VoIP voice
entity is SIP.
If you execute this command, the
default port number for the VoIP
voice entity is 5061. For more
information, see the address sip
command in HPE FlexNetwork
MSR Router Series Comware 5
Voice Command Reference.
Remarks
N/A
N/A
N/A
By default, the TLS listening port
is disabled.