Configuring A Sip Trunk Account - HP FlexNetwork MSR Series Configuration Manual
Hide thumbs
Also See for FlexNetwork MSR Series:
- Command reference manual (1005 pages) ,
- Configuration manuals (159 pages)
Table of Contents
Advertisement
The following table describes how source address binding works in different conditions:
Condition
Configure a source address binding when
ongoing calls exist.
The bound source interface or the
interface whose IP address is set as the
source address is shut down.
The bound static IP address is removed or
modified, or the bound interface is
removed.
The bound interface is disconnected.
Configure a source address binding when
the physical layer or link layer state of the
corresponding interface is down.
The DHCP lease duration expires and the
bound interface dynamically obtains a new
IP address from the DHCP server
The SIP registrar is enabled.
Configuring a SIP trunk account
This section describes how to create, enable, and configure a SIP trunk account.
Configuring a SIP trunk account for registration
SIP trunk accounts are used to manage various information allocated to users by the carrier. You can
configure the authentication username, authentication password, host name, host username, and
the associated SIP server group for a SIP trunk account.
To configure a SIP trunk account for registration:
Step
1.
Enter system view.
2.
Enter voice view.
3.
Create a SIP trunk
account and enter
account view.
4.
Enable the SIP trunk
account.
Result
•
A new source address binding for media does not take
effect for ongoing SIP media sessions but takes effect for
subsequent SIP media sessions.
•
A new source address binding for signal takes effect
immediately for all SIP signaling sessions.
The source IP address binding becomes invalid and will not
work until the interface is up. During the shutdown period, the
gateway automatically gets a source IP address for sent
signaling or media flows.
The source IP address binding is removed.
The source IP address binding is cancelled, and restored
when the interface is connected.
The source address binding does not take effect and the
gateway automatically gets a source IP address for packets.
The new IP address will be used as the source IP address.
The subsequent registration update messages use the source
IP address newly bound for signaling streams to initiate
registration.
Command
system-view
voice-setup
sip-trunk account index-number
account enable
202
Remarks
N/A
N/A
N/A
Optional.
Enabled by default.
Advertisement
Table of Contents
Troubleshooting
