HP FlexNetwork MSR Series Configuration Manual page 353

Step
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Configure the timeout interval
for a user to dial the next digit in
a two-stage dialing process.
Configuring the number of digits in a card number/password
For the card number/password process, it is necessary to stipulate the number of digits in a card
number/password. This facilitates user management and access control.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the number of digits in a card number and that in a password:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Specify the two-stage dialing
process as the card
number/password process.
6. Configure the number of digits
in a card number.
7. Configure the number of digits
in a password.
NOTE:
If a user is required to press the dial terminator # after dialing a card number but fails to do so, the
voice gateway will prompt timeout and require the user to redial the card number. This rule also
applies to a password.
Command
voice-setup
dial-program
gw-access-number access-number
timer two-stage dial-interval seconds
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
process-config cardnumber
card-digit card-digit
password-digit password-digit
340
Remarks
N/A
N/A
N/A
The default is 10
seconds.
Remarks
N/A
N/A
N/A
N/A
N/A
The default is 12.
This command applies only to
the card number process. It is
unavailable in the case of the
caller number process and
caller number process with
IVR.
The default is 6.
This command applies only to
the password process. It is
unavailable in the case of the
caller number process and
caller number process with
IVR.