HP FlexNetwork MSR Series Configuration Manual page 354

Configuring the number of redial attempts
The redialtimes command applies only to the card number/password process and the caller number
process with IVR. This command is unavailable in the case of the caller number process.
For the card number/password process, a user first dials an access number, then selects a language
option, next enters a prepaid card number and password, and finally dials a called number. The user
can retry in each step of this process. To prevent any dial mistake from causing a failure of the entire
dialing process, specify the maximum number of dial attempts to provide fault tolerance.
For the caller number process with IVR, the number of redial attempts refers to the times a called
number can be redialed, and if you have enabled the language selection function, you should also
specify the maximum number of language selection attempts.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the number of redial attempts:
Step
1. Enter system view.
2. Enter voice view.
3. Enter dial program view.
4. Enter access number view.
5. Specify the two-stage dialing
process as card
number/password process
or caller number process
with IVR.
6. Configure the number of
redial attempts.
Enabling the language selection function
The language selection function applies to only the caller number process with IVR. With the
language selection function enabled, the voice gateway will play tones to prompt for a language first
and then a called number after a user dials an access number.
Configuration prerequisites
You have configured an access number and entered access number view.
Configuration procedure
To configure the language options:
Command
system-view
voice-setup
dial-program
gw-access-number
access-number
process-config cardnumber
or process-config
voice-caller
redialtimes
redialtimes-number
341
Remarks
N/A
N/A
N/A
N/A
N/A
For the card number/password
process, the number of redial
attempts applies to each dial step,
including selecting a language
option, and dialing a card number,
password, or called number.
The default is 3.
Use this command to configure the
number of redial attempts.
Therefore, the number of dial
attempts is the number of redial
attempts plus 1. For example, if the
number of redial attempts is n
(redialtimes-number = n), then the
number of dial attempts is n + 1.