Configuring None Authentication For Modem Dial-In; Configuring Password Authentication For Modem Dial-In - HP MSR Series Configuration Manual

Configuring none authentication for modem dial-in

Step
1. Enter system view.
2. Enter one or more AUX user
interface views.
3. Enable none authentication
mode.
4. Configure common settings
for the AUX user interfaces.
The next time you attempt to dial in to the device, you do not need to provide any username or password,
as shown in
Figure 33 Dialing in to the device without any authentication

Configuring password authentication for modem dial-in

Step
1. Enter system view.
2. Enter one or more AUX user
interface views.
3. Enable password
authentication.
4. Set a password.
5. Configure common settings
for AUX user interfaces.
Figure 33.
Command
system-view
user-interface aux first-number
[ last-number ]
authentication-mode none
See "Configuring common settings
for modem dial-in (optional)."
Command
system-view
user-interface aux first-number
[ last-number ]
authentication-mode password
set authentication password
{ cipher | simple } password
See "Configuring common settings
for modem dial-in (optional)."
58
Remarks
N/A
N/A
N/A
Optional.
Remarks
N/A
N/A
By default, password
authentication is enabled, but no
password is configured. To access
the device through the AUX port,
you must configure a password for
authentication.
By default, no authentication is
performed for modem dial-in users.
By default, no password is set.
Optional.