Display Mpls Static-Lsp - HP 5800 series Command Reference Manual

Syntax
display mpls route-state [ vpn-instance vpn-instance-name ] [ dest-addr mask-length ] [ | { begin |
exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
vpn-instance vpn-instance-name: Displays the LSP information of the routes of a VPN instance. vpn-
instance-name is the VPN instance name, which is a case-sensitive string of 1 to 31 characters.
dest-addr mask-length: Displays the LSP information of routes to a destination address. dest-addr is the
destination IP address. The mask length is ranging from 0 to 32.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
•
exclude: Displays all lines that do not match the specified regular expression.
•
include: Displays all lines that match the specified regular expression.
•
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256
•
characters.
Examples
# Display LSP-related information about all routes.
<Sysname> display mpls route-state
DEST/MASK
-----------------------------------------------------------------
1.1.1.1/32
Table 39 Command output
Field
LSP-COUNT
VPN-INDEX

display mpls static-lsp

Description
Use the display mpls static-lsp command to display information about a specific static LSP or all static
LSPs.
Related commands: display mpls lsp and display mpls statistics lsp.
Syntax
display mpls static-lsp [ lsp-name lsp-name ] [ { exclude | include } dest-addr mask-length ] [ verbose ] [ |
{ begin | exclude | include } regular-expression ]
NEXT-HOP OUT-INTERFACE
10.0.0.1 Vlan2
STATE LSP-COUNT VPN-INDEX
ESTA 1 0
Description
Number of LSPs established based on this route
Index number of the VPN instance
80