Mpls L2Vc; Mpls L2Vpn - HP 5800 series Command Reference Manual

[Sysname-bgp] l2vpn-family
[Sysname-bgp-af-l2vpn]

mpls l2vc

Description
Use the mpls l2vc command to create a Martini L2VPN connection.
Use the undo mpls l2vc command to delete the Martini connection on the CE interface.
If you do not specify a tunneling policy for a VC or the specified tunneling policy is not configured, the
VC selects tunnels by using the default tunneling policy. The default tunneling policy selects only one
tunnel (no load balancing) in this order: LSP tunnel, CR-LSP tunnel.
Related commands: tunnel-policy.
Syntax
mpls l2vc destination vcid [ tunnel-policy tunnel-policy-name ] [ control-word | no-control-word ]
undo mpls l2vc
View
Interface view
Default level
2: System level
Parameters
destination: Specifies the IP address of the peer PE.
vc-id: Specifies the VC ID of the L2VPN connection, ranging from 1 to 4,294,967,295.
tunnel-policy-name: Specifies the tunneling policy for the VC, which is a string of 1 to 19 characters.
control-word: Enables the control word option.
no-control-word: Disables the control word option.
NOTE:
The HP 5800 switch series do not support the control word option.
Examples
# Create a Martini MPLS L2VPN connection.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] mpls l2vc 2.2.2.9 999

mpls l2vpn

Description
Use the mpls l2vpn command to enable MPLS L2VPN.
Use the undo mpls l2vpn command to disable MPLS L2VPN and delete all L2VPN configurations.
259