Mpls Te Configuration Commands; Add Hop - HP 5800 series Command Reference Manual

MPLS TE configuration commands

NOTE:
For information about VPN, see the MPLS Configuration Guide.
•
This chapter supports tunnel interfaces, VLAN interfaces, and Layer 3 Ethernet interfaces. A Layer 3
•
Ethernet interface refers to an Ethernet interface working in route mode. For information about the
operating modes of an Ethernet interface, see the
The HP 5820X switch series do not support MPLS TE.
•

add hop

Description
Use the add hop command to insert a node to the explicit path.
By default, the specified node is included in the explicit path, and its next hop is a strict node.
Syntax
add hop ip-address1 [ include [ loose | strict ] | exclude ] { after | before } ip-address2
View
Explicit path view
Default level
2: System level
Parameters
ip-address1: Specifies the IP address or Router ID of the node to be inserted in the explicit path, in dotted
decimal notation.
include: Includes the specified IP address in the explicit path.
loose: Indicates that the next hop is a loose node which is not necessarily directly connected to the
specified node.
strict: Indicates that the next hop is a strict node which must be directly connected to the specified node.
exclude: Excludes the node identified by the ip-address1 parameter from the explicit path. Excluded
addresses are not considered in path calculation.
after: Inserts the node identified by the ip-address1 parameter after the reference node.
before: Inserts the node identified by the ip-address1 parameter before the reference node.
ip-address2: Specifies the IP address of the reference node, in dotted decimal notation.
Examples
# Insert 3.3.29.3 behind 3.3.10.5 on the explicit path PL and exclude this IP address in path calculation.
<Sysname> system-view
[Sysname] explicit-path path1
[Sysname-explicit-path-path1] add hop 3.3.29.3 exclude after 3.3.10.5
Layer 2—LAN Switching Configuration Guide
115
.