Selecting Lock Mode 2 Or Toggling Between Mode 2 And Mode 0; Selecting Lock Mode 2 Or Toggling Between Mode 2 And Mode 1 - Extron electronics DTP CrossPoint 4K Series User Manual

Selecting Lock mode 2 or toggling between mode 2 and mode 0

NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2. The
, , and
Esc Video Audio
If the switcher is in Lock mode 2, this procedure selects mode 0 (unlocks the
switcher). The and
Video
Toggle the lock on and off by pressing and holding the
the button simultaneously for approximately 2 seconds (see figure 32).
Audio
Lock mode 2
CONTROL
ENTER PRESET VIEW ESC VIDEO
Press and hold for 2 seconds.
Lock mode 0
CONTROL
ENTER PRESET VIEW ESC VIDEO
Press and hold for 2 seconds.
Figure 32. Toggling Front Panel Lock Between Mode 2 and Mode 0

Selecting Lock mode 2 or toggling between mode 2 and mode 1

NOTES:
•
If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
• If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the
simultaneously for approximately 2 seconds (see figure 33).
Lock mode 1
I/O
VIDEO AUDIO VIDEO
Press and hold for
2 seconds.
Figure 33. Toggle Front Panel Lock Between Mode 2 and Mode 1
buttons blink twice.
buttons blink twice.
Audio
I/O I/O
AUDIO VIDEO AUDIO
I/O CONTROL
AUDIO ENTER PRESET VIEW
Lock mode 0
I/O
I/O
AUDIO
VIDEO AUDIO
Press and hold for
2 seconds.
DTP CrossPoint 4K Series Matrix Switchers • Operation
button, the button, and
Enter Video
I/O
ESC VIDEO AUDIO
button and the
Video Audio
CONTROL
ENTER PRESET ESC
VIEW VIDEO
button
I/O
AUDIO
49