Extron electronics DTP CrossPoint 4K Series User Manual page 142

6. If you made additional ties from the same input, press <Enter> to execute the tie.
7. If desired, repeat steps 5 and 6 to tie additional outputs to the same input.
8. If desired to make ties from a different input, press left arrow
steps 1 through 7.
9. Press <Tab> , <Esc> , right arrow
Highlighting and marking items, cutting or copying, saving a preset
When an item within the program is selected, it is green highlighted. One or more
highlighted items can be cut, copied, pasted, or saved as a preset. The cut, copy, and
paste functions can be performed using the task bar menus (see
page) or the shortcuts described on the previous page.
NOTE: When an item is cut, it is not removed from its original location until it has been
pasted in its new location.
Highlight multiple elements for cut, copy, paste, or a preset as follows:
1.
Use arrows ( , , , and
2. To highlight sequential blocks, press and hold <Shift>, then use arrows
( , , , and ) to navigate to and highlight additional elements.
When you reach the last element you want highlighted, release <Shift>.
3. To highlight non-sequential blocks:
a. Press and hold <Ctrl>, then use arrows ( ,
next desired element
b. Release <Ctrl>.
c. To highlight sequential blocks, press and hold <Shift>, then use arrows ( ,
, , and ) to navigate to and highlight additional elements.
d. To move away from the highlighted block or set of sequential blocks, press
and hold <Shift>, then use arrows ( ,
away from the last-highlighted element.
NOTE: If you do not perform step 3c, the last selected element will not remain
highlighted.
e. Release <Shift>.
4. To highlight another element or group of elements, repeat steps 1 through 3.
5. To cut or copy, press the <Ctrl>-<X> or <Ctrl>-<C> combination.
6. To save a preset, press <Alt>, then <T>, then right arrow
then <Enter> (see
figure 74
The dialog box opens.
Save a Preset
a. As desired, <Tab> to the
number.
b. As desired, <Tab> to the
NOTE: Unless you enter a specific number, name, or both, DSP Configurator
enters the next sequential unused preset number and the name
.
number
c. Press <Tab> to highlight the
DTP CrossPoint 4K Series Matrix Switchers • Matrix Software
, or left arrow to exit the set ties operation.
) to move to the first block to highlight.
, , and
, , or
) .
on the next page, 1
field ( ) and enter a specific preset
Preset Number 2
field ( ) and enter a preset name.
3
Preset Name
button ( ) and press <Enter> (
4
OK
once, and repeat
<Alt> key on the previous
) to navigate to the
) to move the highlighting box
, then down arrow
,
Preset
).
5
134