Locking And Unlocking The Front Panel (Executive Modes); Selecting Lock Mode 2 Or Toggling Between Mode 2 And Mode 0 - Extron electronics DXP DVI Pro User Manual

Locking and Unlocking the Front Panel (Executive Modes)

The matrix switchers have three levels of front panel security lock that limit the operation
of the switcher from the front panel:
•
•
•
Basic functions include:
•
•
•
Advanced functions include:
•
•
•
NOTE:

Selecting Lock Mode 2 or Toggling Between Mode 2 and Mode 0

NOTE:
Toggle the lock on and off by pressing and holding the Enter, Video, and Audio buttons
simultaneously until the following buttons blink twice (approximately 2 seconds).
•
•
Press and hold the Enter, Video, and Audio buttons
simultaneously to enable lock mode 2 or to toggle
between mode 2 and mode 0.
Figure 58.
Lock mode 0 — The front panel is completely unlocked. All front panel functions are
available.
Lock mode 1 — All changes are locked from the front panel (except for setting lock
mode 2). Some functions can be viewed.
Lock mode 2 — Basic functions are unlocked. Advanced features are locked and can
only be viewed.
Making ties
Saving and recalling presets
Changing lock modes
Creating I/O groups
Setting video and audio output mutes
Setting the rear panel Remote RS232/RS422 port protocol and baud rate
The switcher is shipped from the factory in lock mode 2.
If the switcher is in lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in lock mode 2, this procedure selects mode 0 (unlocks the
switcher).
The Esc, Video, and Audio buttons blink if the DXP is now in lock mode 2.
The Video and Audio buttons blink if the DXP is now in lock mode 0.
I / O
2 seconds
ENTER VIDEO AUDIO
Toggle Front Panel Lock Between Mode 2 and Mode 0
The Esc, Video, and Audio buttons
blink twice to indicate mode 2.
I / O
The Video and Audio buttons blink
twice to indicate mode 0.
ENTER VIDEO AUDIO
Release the buttons.
DXP DVI Pro and DXP HDMI Series • Operation 37