Presets - Extron electronics DTP CrossPoint 4K Series User Manual

The audio-only I/O page, selected by clicking
View > Audio I/O
Video & Audio I/O
available. Switching operations using the AV matrix block (see
page 110) tie only audio.

Presets

The DTP CrossPoint 4K Series can store up to 32 presets and can include both selected
ties and selected audio signal processing settings made in the program. Presets that do not
include a full configuration of ties and settings, when recalled, overwrite only a portion of the
current configuration, leaving other ties and settings unchanged, and are useful when only
selected ties, settings, or both; such as for a particular room; need to be changed.
Save a preset
Before you save a preset using the DSP Configurator program, you must select (mark) the
desired ties and signal processor blocks. Save a preset as follows:
1.
Mark the desired video and audio ties as desired:
a. Click an output node ( ). The node is marked by a green outline ( ).
The output and the tied input are selected to be saved as a preset.
b. Ctrl-click additional outputs as desired.
TIPS:
•
•
2. Mark the desired mic mix-points:
a. Click a mix-point ( ). The point is marked by a green outline ( ).
The mic/line input, the mixed output, and all mix settings are selected to be saved
as a preset.
b. Ctrl-click additional mix-points as desired.
TIPS:
•
•
, or pressing the keyboard <F3> key. The appearance is identical to the
figure 53
page (see
If an input is tied to multiple outputs, and you want the entire set of ties saved
as a preset, mark each output to save that tie.
To mark multiple successive outputs (marking all outputs selects all ties),
mark the uppermost output node as described in step 1a. Then,
Shift-click an output node under it to mark all of the outputs between
the two nodes.
To mark the same mic/line input mix-point for a successive series of
outputs, mark the leftmost or rightmost mix-point as described in
step 2a. Then, Shift-click a mix-point to the left or right of it to mark each
mix-point in the row (mix the mic/line input to each output).
To mark the same output mix-point for a successive series of mic/line
inputs, mark the uppermost mix-point as described in step 2a. Then,
Shift-click a mix-point under it to mark each mix-point in the column
(mix the output to each mic/line input).
DTP CrossPoint 4K Series Matrix Switchers • Matrix Software
in the legend field, clicking
Audio Only
on page 97), and the same audio controls are
AV matrix block ( ) on
C
124